Frequently Asked Questions
How long do brushes last?
Estimate on current usage for Polyethylene brushes is 15,000 washes, Foam Brushes last over 40,000 washes
Do the brushes scratch the vehicles paint or clear coat?
Soft polyethylene brushes have been used for over 29 years with no issues. As with any product you need to clean and replace when worn. We will guide you through the process, but understand, its not the brush that scratches, its the dirt in the brushes.
Foam brushes are superior in cleaning and polishing. Foam is impenetrable, thus no water, dirt or grit can attach to the strands to cause scratching.
How do you replace brushes?
Brushes are in 1 foot sections. It’s as easy as replacing two screws and two bolts/nuts.
What kind of washing can we do?
Any vehicles 14 feet height and under can be washed in 5 minutes or less. We have manufactured machines as high as 18 feet tall. We are the OEM, so nothing is impossible.
What are the benefits of an Awash machine over hand washing?
Staff stays dry and clean.
Wash time requires minimal physical effort.
Machine is always there, ready to work.
Lasts longer than most employees.
Can I add more chemicals than just soap?
Yes, there are options available for rinse, degreaser, reverse osmosis, soft water, etc.
How much soap is used per wash?
Less than 1 ounce of soap is used per minute. Cost is between $0.30 to $0.50 per wash depending on hard or soft water conditions at your facility.
What are the maintenance requirements of this system?
Very low requirements versus any system on the market since there is only a 2hp motor turning the shaft. All other components run on water pressure.
Awash has Preventive Maintenance and Service Programs available for DIY or Technician visits. Customer Care Dept. will contact you 2X per year.
All Parts are warehoused and available for immediate delivery.
What kind of specialized training for staff is required?
Machines and systems are all automated. One usage of the machine is typically the amount of training required.
Do I need permits to install?
No, this system is equivalent to a piece of equipment such as a pressure washer. No structural changes are required.
What drainage do I need?
System only uses 3 to 5 gallons of water per minute, approximately the same as a pressure washer. Regular sewer drainage is the only requirement.
What structure do I need to have available for installation?
For Inside Wash Bay: No structural changes required, only an area to install an overhead roller system, 220V plug, 15 or 20amp (single or 3 phase) and a regular city water tap. Send us pictures of your desired area and we can figure it out for you.
For Outside Wash Bay: There are many choices available from hangers on a building, poles set up on a concrete pad to cable strung under a canopy. Send us the pictures of your desired area and we will figure out the best scenarios.
Where Can I Install a machine?
Inside a Building: Anywhere inside that has minimum 3 feet clearance around your vehicle and 16” clearance over the vehicle
Outside your Facility: Anywhere outside that has 4 feet clearance around your vehicle.
More Questions?
Just send us a note and we will be back to you in less than 24 hours!
